NETGEAR MR814 v3 - Manual (Page 39)

Reference Manual for the MR814 v3 Cable/DSL Wireless Router
Connecting the Router to the Internet 3-15
202-10039-01
Note: After you finish setting up your router, you will no longer need to launch the ISP’s login
program on your computer in order to access the Internet. When you start an Internet
application, your router will automatically log you in.
a. Select you Internet service provider from the drop-down list.
Figure 3-11: Basic Settings ISP list
Note: Not all ISPs are listed here. The ones on this list have special requirements.
b. The screen will change according to the ISP settings requirements of the ISP you select.
c. Fill in the parameters for your Internet service provider.
d. Click Apply to save your settings. Click the Test button to verify you have Internet access.
Using the Smart Setup Wizard
You can use the Smart Setup Wizard to assist with manual configuration or to verify the Internet
connection. The Smart Setup Wizard is not the same as the Smart Wizard configuration assistant
(as illustrated in
Figure 3-5 ) that only appears when the router is in its factory default state. After
you configure the router, the Smart Wizard configuration assistant will not appear again.
To use the Smart Setup Wizard to assist with manual configuration or to verify the Internet
connection settings, follow this procedure.
1. Connect to the router by typing http://www.routerlogin.net in the address field of your
browser, then click Enter.