NEC NP3151W - Manual (Page 36)


2. Installation and Connections
Connecting the Supplied Power Cable
Connect the supplied power cable to the projector.
First connect the supplied power cable’s three-pin plug to the AC IN of the projector, and then connect the other
plug of the supplied power cable in the wall outlet.
LAM P STATUS POWER
ON/S TAND BY
SOU RCE
AUT O ADJUST
3D RE FORM
SELEC
T
USB
LENS S
HIFT
LEFT
RIGHT
DOWN
UP
WIRELESS
WIRELES
S
Make sure that the prongs are fully
inserted into both the aC in and the
wall outlet.
to wall outlet
LEN S SHIF T
LEF T
TIP: To turn off the AC power supply when the projector is powered on, use a power strip equipped with a switch and a breaker.
CAUTION:
Do not try to touch the ventilation outlet on the left front (when seen from the front) as it can become heated
while the projector is turned on and immediately after the projector is turned off.
CAUTION:
Do not unplug the power cable from the wall outlet or projector when the projector is powered on. Doing so can
cause damage to the AC IN connector of the projector and (or) the prong plug of the power cable.
About Direct power Off
The projector has a feature called “Direct Power Off”. This feature allows the projector to be turned off (even when
projecting an image) using a power strip equipped with a switch and a breaker.
NOTE: Before using Direct Power Off, be sure to allow at least 20 minutes immediately after turning on the projector and starting
to display an image.