NETGEAR DG834GSP - Manual (Page 119)

Reference Manual for the ADSL Modem Wireless Router DG834GSP
Virtual Private Networking 8-7
v1.0, June 2007
How to Set Up a Client-to-Gateway VPN Configuration
Setting up a VPN between a remote PC running the NETGEAR ProSafe VPN Client and a
network gateway involves the following two steps:
• “Step 1: Configuring the Client-to-Gateway VPN Tunnel on the DG834GSP” on page 8-7 uses
the VPN Wizard to configure the VPN tunnel between the remote PC and network gateway.
• “Step 2: Configuring the NETGEAR ProSafe VPN Client on the Remote PC” on page 8-12
configures the NETGEAR ProSafe VPN Client endpoint.
Step 1: Configuring the Client-to-Gateway VPN Tunnel on the
DG834GSP
The worksheet below identifies the parameters used in the following procedure. A blank
worksheet is at
“Planning a VPN” on page 8-4 .
Figure 8-3
Note: This section uses the VPN Wizard to set up the VPN tunnel using the VPNC
default parameters listed in Table 8-2 on page 8-5 . If you have special requirements
not covered by these VPNC-recommended parameters, refer to “How to Set Up
VPN Tunnels in Special Circumstances” on page 8-38 to set up the VPN tunnel.
192.168.3.1
VPN Tunnel
DG834G
22.23.24.25
PC
(Running NETGEAR
ProSafe VPN Client)
PCs
0.0.0.0