NEC XT5000 - Manual (Page 20)

E – 20
OUTPUT OUTPUT
RGB
DIGITAL
INPUT9 INPUT 0
SDI
OUTPUT OUTPUT
RGB
DIGITAL
INPUT9 INPUT 0
SDI
OUTPUT OUTPUT
RGB
DIGITAL
INPUT9 INPUT 0
SDI
OUTPUT
OUTPUT
INPUT9
INPUT9
DFP cable (supplied)
DFP cable (supplied)
Master projector
Slave projector
INPUT3
RGB R/Cr
G/Y
B/Cb
H/HV
V
R/Cr Cr
Y G/Y
B/Cb Cb
H/HV
V
OPTION
IN
OUT
REMOTE1
INPUT2 INPUT1 INPUT4
INPUT3
RGB R/Cr
G/Y
B/Cb
H/HV
V
R/Cr Cr
Y G/Y
B/Cb Cb
H/HV
V
OPTION
IN
OUT
REMOTE1
INPUT2 INPUT1 INPUT4
INPUT3
RGB R/Cr
G/Y
B/Cb
H/HV
V
R/Cr Cr
Y G/Y
B/Cb Cb
H/HV
V
OPTION
IN
OUT
REMOTE1
INPUT2 INPUT1 INPUT4
For double or triple stacking, follow the instructions described below.
1) Stacking the Projectors
1-1. Place the projectors at the proper height for best screen to
projector relationship. Make sure that all projectors have the
same display orientation.
2) Hookup
2-1. Use the supplied DFP cable to connect the RGB DIGITAL
output (INPUT 9) of the master projector to the RGB DIGITAL
input of the slave projector (the second and third stack) until
all the projectors are connected.
2-2. Next, using a commercially available, bi-directional RS-232C
cable connect the OPTION OUT terminal of the master pro-
jector to the OPTION IN terminal of the slave projector(s) until
all the projectors are connected.
NOTE: When inputting signals other than those listed on page E-
44, use a commercially available distribution amplifier between
the projector and those signals because those signals are not com-
patible with this projector in the Digital Link mode.
2-3. Turn all the projectors on and roughly make some optical
adjustments to each projector.
Setting up for Double or Triple Stacking in Link
Mode
bi-directional RS-
232C cable
(not supplied)
NOTE: SW 1 Level and SW 2 Level of Switcher Control are not available on Link Mode.