NEC MultiSync MT600 - Manual (Page 15)

• Supports most IBM VGA, S-VGA (pseudo), Macintosh or any
other RGB signals within a horizontal frequency range or 15 to
40 kHz and a vertical frequency range of 50 to 75 Hz. This
includes NTSC, PAL, SECAM, and M-NTSC standard video
signals.
Note: Composite video standards are as follows:
NTSC: U.S. TV standard for video in U.S.
and Canada.
PAL: TV standard used in western Europe
SECAM: TV standard used in France and
Eastern Europe
M-NTSC: (modified-NTSC)-result of converting
a video in the SECAM standard to
the NTSC standard
14 INTRODUCTION
• The remote control can be used with or without a cable, and
you can even use the remote to operate your PC or Macintosh
mouse wirelessly from across the room with the IR receiver
module.
• You can control your MultiSync MT600 LCD Projector with a
PC.
• The contemporary cabinet design is compact, easy to carry,
a n d c o m p l e m e n t s a n y o ff i c e , b o a r d r o o m o r
auditorium.
* Installing the MultiSync MT600 LCD Projector on the ceiling
must be done by authorized NEC technicians. Consult your
NEC dealer for more information.
This section helps you resolve problems you may encounter while setting up or using
your MultiSync MT600 LCD Projector.
Status Light Messages
Condition Status
OFF Normal
On Continually The projector lamp has exceeded
2000 hours of operation and
should be replaced.
Blinking Slowly Check the filter and clean it if necessary.
(Once a second)
Ensure that the filter panel is
installed properly.
Wait one minute before using the remote
control. Otherwise the lamp may not go on.
49
T R O U B L E S H O O T I N G 5