NEC MultiSync MT600 - Manual (Page 3)

RF Interference
WARNING
The Federal Communications Commission does not allow any
modifications or changes to the unit EXCEPT those specified by
NEC Technologies in this manual. Failure to comply with this
government regulation could void your right to operate this equip-
ment.
This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a commercial installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
2
WARNING
TO PREVENT FIRE OR SHOCK, DO NOT EXPOSE THIS
UNIT TO RAIN OR MOISTURE. DO NOT USE THIS UNIT’S
GROUNDED PLUG WITH AN EXTENSION CORD OR IN
AN OUTLET UNLESS ALL THREE PRONGS CAN BE
FULLY INSERTED. DO NOT OPEN THE CABINET. THERE
ARE HIGH-VOLTAGE COMPONENTS INSIDE. ALL SER-
VICING MUST BE DONE BY QUALIFIED NEC SERVICE
PERSONNEL.
Command Codes (continued)
No. Function Code Data Description
33 Lamp Reset 27H No Lamp usage hour is reset to 0
34 S-VIDEO C6H No Same as remote
35 Brightness 60H Yes 0 to 63
36 Contrast 62H Yes 0 to 63
37 Color 64H Yes 0 to 63
38 Tint 66H Yes -32 to +31(E0 to 1F)
39 Sharpness 68H Yes 0 to 3
40 Audio Volume 6AH Yes 0 to 63
41 Fine Picture 6EH Yes 0 to 15
42 Picture Adj 70H Yes 0 to 255
43 H Position 72H Yes -32 to +31(E0 to 1F)
44 V Position 74H Yes -32 to +31(E0 to 1F)
61