NEC MultiSync MT600 - Manual (Page 32)

32
1. Turn off the power to your LCD projector and computer, document camera or video
source.
2. Use a 15-pin cable to connect your monitor to either available 15-pin connector on
your LCD projector.
3. Turn the External Monitor Select Switch on the Terminal Panel to “on.”
4. Turn on the LCD projector and the computer, document camera or video source.
Connecting Your IR Mouse Receiver
The IR Receiver enables you to operate your computer’s mouse functions from the
NEC MultiSync MT600 remote control. It is a great convenience for clicking through
your computer-generated presentations.
To connect the IR Receiver:
1. Turn off your computer.
2. For PCs: Remove your current mouse and connect the serial cable from the IR
Receiver to your PC’s mouse port. (Use the 6-pin adapter for connecting to a PS/2
computer.)
For Macintosh: Remove your current mouse from your computer, attach the
Macintosh adapter to the IR Receiver’s serial cable, and connect the receiver to
your mouse port.
INSTALLATION
31
Connecting Your VCR Or Laser Disc Player
You use a common coaxial cable and RCA audio cables (not provided) to connect your
VCR or laser disc player to your MultiSync MT600 LCD Projector. To make these
connections, simply:
1. Turn off the power to your LCD projector and VCR or laser disc player.
2. Connect one end of your coaxial video cable to the video output connector on the
back of your VCR or laser disc player, connect the other end to your projector. Use
standard RCA audio patch cords to connect the audio from your VCR or laser disc
player to your projector (if your VCR or laser disc player has this capability). Be
careful to keep your right and left channel connections correct for stereo sound.
3. Turn on the LCD projector and the VCR or laser disc player.
NOTE: Refer to your VCR or laser disc player owner’s manual for more information
about your equipment’s video output requirements.
Connecting An External Monitor
You can connect a separate, external monitor to your LCD projector to simultaneously
view on a monitor the image you’re projecting. To do so: