2) selecting a source, Selecting the computer or video source, Selecting a source – NEC NP41 User Manual
Page 27: Projectng an image (basc operaton), Selectng the computer or vdeo source, Adjustng wth buttons on the cabnet, Usng the remote control
8
3. Projectng an Image (Basc Operaton)
SELECT
SOURCE
AUTO
ADJ.
ON/STAND BY
FOCUS
LAMP
STATUS
POWER
➋
Selecting a Source
Selectng the computer or vdeo source
VOLUME ASPECT
HELP
FOCUS
L-MOUSE-R
FREEZE
PICTURE
LAMP MODE
VIDEO
AUTO ADJ.
COMPUTER
S-VIDEO VIEWER
NOTE: Turn on the computer or video source equipment connected to the projector.
Adjustng wth buttons on the cabnet
1. Press the seleCt
▶ (sOUrCe) button with no menus displayed.
The Source list will be displayed.
- When the menu is displayed, press the EXIT button to close the menu
and start the operation.
2. Press the seleCt
▶ button a few times quickly to select a signal
you want to display.
Each time the SELECT
▶ button is pressed, each source name will be
highlighted in sequence.
- The selected signal will be displayed.
TIP: Detecting the Signal Automatically
Press and hold the SELECT
▶ button for a minimum of 2 seconds, the projector
will search for the next available input source.
Detecting the signal automatically is not available for the Viewer source on the
NP62 and NP52.
Usng the Remote Control
Press any one of the VIDEO, S-VIDEO, COMPUTER, and VIEWER
buttons.
NOTE: The VIEWER button is not available on the NP61 and NP41.
NP61/NP41
NP62/NP52