5) correcting keystone distortion manually, Correcting keystone distortion manually, Projectng an image (basc operaton) – NEC NP41 User Manual
Page 34: Adjustng wth buttons on the cabnet, Adjustng wth the remote control
3. Projectng an Image (Basc Operaton)
SELECT
SOURCE
AUTO
ADJ.
ON/STAND BY
FOCUS
LAMP
STATUS
POWER
➎
Correcting Keystone Distortion Manually
You can also correct the vertical keystone distortion manually.
NOTE:
• Keystone correction by using the SELECT
▲/▼ button is not possible when [VIEWER] is selected for the source.
• The vertical keystone angle can be corrected between 40 degrees upward and 40 degrees downward from level.
Adjust the keystone distortion manually in the following cases:
• To fine tune Keystone correction even after performing the [AUTO KEYSTONE] adjustment
• When the menu setting for [AUTO KEYSTONE] is turned off
Adjustng wth buttons on the cabnet
1. Press the seleCt
▲ or ▼ button with no menus dis-
played.
The slide bar will be displayed for your adjustment.
2. Press the eXit button.
The slide bar will be closed.
Adjustng wth the remote control
1. Press the MenU button.
The menu will be displayed.
2. Press the seleCt
▶ button to select [setUP] and
press the enter button.
The [GENERAL] screen will be displayed.
3. Press the seleCt
▼ button to select [KeYstOne].
NP62/NP52