NEC NP41 - Manual (Page 75)


. Usng On-Screen Menu
Enablng Key Sound and Error Sound [BEEP]
This feature turns on or off the button sound or alarm when the following operations are performed.
- displaying the main menu
- switching sources
- Resetting data by using [RESET]
- Pressing POWER ON or POWER OFF button
[OPTIONS()]
Usng Off Tmer [OFF TIMER]
1. select your desired time between 30 minutes and 16 hours: Off, 0:30, 1:00, 2:00, 4:00, 8:00, 12:00,
16:00.
2. Press the enter button on the remote control.
3. the remaining time starts counting down.
4. the projector will turn off after the countdown is complete.
NOTE:
• To cancel the preset time, set [OFF] for the preset time or turn off the power.
• When the remaining time reaches 3 minutes before the projector is turned off, the [THE PROJECTOR WILL TURN OFF WITHIN
3 MINUTES] message will be displayed on the bottom of the screen.
Selectng Power-savng n [STANDBY MODE]
The projector has two standby modes: [NORMAL] and [POWER-SAVING].
Power-saving mode is the mode that allows you to put the projector in the power-saving condition which con-
sumes less power than the NORMAL mode. The projector is preset for NORMAL mode at the factory.
NOTE:
• Control through the PC Control connector is not available during POWER-SAVING mode. For PC control of the projector it is
recommended to leave the projector in the Normal mode.
• Your setting will not be affected even when [RESET] is done from the menu.
NORMAL ....................... Power indicator: Orange light/STATUS indicator: Green light
POWER-SAVING ........... Power indicator: Orange light/STATUS indicator: Off