Renesas M3062PT-EPB - Manual (Page 43)

( 41 / 80 )
3.6.7 Connecting to a 100-pin 0.5-mm-pitch Foot Pattern (Part 2)
Here following is a procedure of connecting to a 100-pin 0.5-mm-pitch foot pattern on the target
system using the M3T-100LCC-QSD (not included). For details on the M3T-100LCC-QSD, refer
to its user's manual.
(1) Attach the M3T-100LCC-QSD to the target system.
(2) Attach the CN2 side of the M30800T-PTC to the J4 side of the M3062PT-EPB.
(3) Attach the M30800T-PTC to the M3T-100LCC-QSD.
Figure 3.18 Connecting to a 100-pin 0.5-mm-pitch foot pattern (Part 2)
CAUTION
Notes on Connecting the Target System:
• Take care not to attach a converter board in a wrong direction. It may cause a fatal
damage to the emulator and targets system.
• The connectors of the M30800T-PTC and M3T-100LCC-QSD are guaranteed for
only 50 insertion/removal iterations.
M3062PT-EPB
100-pin 0.5-mm-pitch (100P6Q) foot pattern
M30800T-PTC
M3T-100LCC-QSD (not included)
Target board
No. 1 pin
CN2 side
M3T-FLX160-EPB
(1)
(3)
(2)