Radio Shack PRO-96 - Manual (Page 35)

35
systems operating in the VHF and
UHF bands. To monitor these
systems it is necessary to program
the scanner with three additional
parameters, the base frequency,
step and offset.
Ó
Follow these steps to program
Motorola trunking frequencies in
the VHF or UHF bands:
1. Press PGM , and then TRUNK
to enter the ID program mode.
2. Press FUNC and press (or
hold)
S
or
T
to select the
bank.
3. Press MODE until Motorola
appears in the display.
4. Press FUNC then 2 . The
display indicates
Base Freq:
406.0000
Offset: 380
Step:25.0kHz
5. While B in Base blinks, if
necessary, enter the desired
Base frequency with the
number keys and press
ENTER . If it is incorrect, press
the number keys again to set
the base frequency.
6. While O in Offset blinks, if
necessary, enter the offset
number and press
ENTER . If it
is incorrect, then press the
number keys again to set the
frequency.
7. While S in Step blinks,
repeatedly press S or T to
select the step number, 5,
Ó
HINTS
Ó
• Base frequency,
step and offset vary
for each individual
UHF trunking
system. You can get
information about
these frequencies for
the trunking system
you want to scan
using
trunkscanner.com,
other Internet
sources, or locally
published
guidebooks.
• Systems with
multiple channel
ranges can be
programmed using
PC application
software.