Radio Shack PRO-96 - Manual (Page 62)

62
C
OPYING A
F
REQUENCY
INTO A
S
PECIFIED
C
HANNEL
You can copy a frequency into a
specified channel when the
scanner stops on that frequency
during search mode or manual
tuning. If a CTCSS or DCS code is
detected on the transmission, the
detected code will be copied into
the channel memory as well.
Ô
1. Press FUNC , and then PGM
when you find a frequency.
Chan Store? appears on the
bottom line. After about 1
second, the frequency to be
copied flashes on the
indicator.
2. Press the desired bank and
the channel number where
you want to store the
frequency. The display
indicates the bank and
channel number, and briefly
displays the frequency that is
currently programmed into the
selected channel. You can
repeat this step as needed
until you find an acceptable
destination channel. After
about 1 second, the
frequency to be copied
flashes.
3. Press ENTER . All the
conditions such as receive
mode and delay condition are
copied onto the channel.
Chan Store! briefly appears in
the scanner’s display. The
scanner automatically returns
to search mode.
Ô
NOTE
Ô
If you try to copy a
frequency that is already
stored, the scanner
sounds the notice tone 3
times after you press
ENTER.
Dupl.f Chxxx
appears at the bottom
line. If you want to copy
the duplicate frequency
anyway, press ENTER,
or if not, press CLR to
cancel.