Roland HPD-15 - Manual (Page 50)

50
Chapter 2 Modifying a Patch
3-Tap Delay (3TapDlySht/3TapDlyLng)
The 3-Tap Delay produces three delay sounds; center, left
and right. The delay time can be specified as a note value of
the tempo of the sequencer.
* There is no difference between Sht and Lng but the length of
the delay time.
Delay C: 20–600ms (Sht), 200–1000ms (Lng), note-value
Delay L: 20–600ms (Sht), 200–1000ms (Lng), note-value
Delay R: 20–600ms (Sht), 200–1000ms (Lng), note-value
Adjusts the time delay from the direct sound until when the
delay sound is heard. This parameter can be set as a note-
value of the tempo of the sequencer. In this case, specify the
value of the desired note.
Feedback: -98–+98%
Adjusts the proportion (%) of the center delay sound that is
fed back into the effect. Negative (-) settings will invert the
phase.
Center Level: 0–127 LFO, Ctrl1
Left Level: 0–127 Ctrl2
Right Level: 0–127 Ctrl3
Adjusts the volume of each delay sound.
HF Damp: 200Hz–8kHz, THRU
Adjusts the frequency above which sound fed back to the
effect will be cut. If you do not want to cut the high
frequencies of the feedback, set this parameter to THRU.
Tone: -15–+15
Adjusts the tone quality. Positive (+) settings will emphasize
the high range, and negative (-) settings will emphasize the
low range.
Effect Level: 0–127 RTM
Adjusts the output level of delay sound.
Direct Level: 0–127
Adjusts the output level of direct sound.
4-Tap Delay (4TapDlySht/4TapDlyLng)
The 4-Tap Delay has four delays. Each of the delay time
parameters can be specified as a note value of the tempo of
the sequencer.
* There is no difference between Sht and Lng but the length of
the delay time.
The stereo location of each delay sound is as follows.
fig.2-18
Delay 1: 20–600ms (Sht), 200–1000ms (Lng), note-value
Delay 2: 20–600ms (Sht), 200–1000ms (Lng), note-value
Delay 3: 20–600ms (Sht), 200–1000ms (Lng), note-value
Delay 4: 20–600ms (Sht), 200–1000ms (Lng), note-value
Adjusts the time delay from the direct sound until when each
delay sound is heard. These parameters can be set as a note-
value of the tempo of the sequencer. In this case, specify the
value of the desired note.
Level 1: 0–127 LFO, Ctrl1
Level 2: 0–127 Ctrl2
Level 3: 0–127 Ctrl3
Level 4: 0–127
Adjusts the volume of each delay sound.
Feedback: -98–+98%
Adjusts the proportion (%) of the delay 1 sound that is fed
back into the effect. Negative (-) settings will invert the
phase.
HF Damp: 200Hz–8kHz, THRU
Adjusts the frequency above which sound fed back to the
effect will be cut. If you do not want to cut the high
frequencies of the feedback, set this parameter to THRU.
Effect Level: 0–127 RTM
Adjusts the output level of delay sound.
Direct Level: 0–127
Adjusts the output level of direct sound.
1
2 3
4
L R