Roland HPD-15 - Manual (Page 71)

71
Chapter 5 Settings for the Entire HPD-15
Chapter 5
Using the Foot Switches to Control the Tone / Sequencer
You can connect two foot switches (BOSS FS-5U, optional) to the FOOT SWITCH jack with the special cable (PCS-31, optional).
See p. 11.
Settings for the Foot Switches
fig.5-07.e
The white plug of the PCS-31 is the SW 1, and the red one is
the SW 2.
If you connect one foot switch with a monaural cable, you
can use it as the SW 1. It is not possible to use the SW 2 in this
case.
You can use the pedal switch DP-2 (optional) as the SW 1. It
is not possible to use the SW 2 in this case.
FOOT SW
FUNCTION SW 1, SW 2 Specifying the Function of the Foot Switch OFF,
PATCH DOWN,
PATCH UP,
REV OFF/ON,
M-FX OFF/ON,
ROLL/HOLD,
PLAY/STOP,
Mdfy SEL DN,
Mdfy SEL UP
OFF: No function is assigned to the foot switch.
Specify the function of the foot switches connected to the
FOOT SWITCH jack.
Parameter Value Category
Mdfy SEL UP: Select the parameter that will be adjusted by realtime modify (p. 19).
The indicator that at the upper right of the realtime modify knobs will
move from bottom to top; the opposite of pressing [SELECT] (Mdfy SEL DN).
Mdfy SEL DN: Select the parameter that will be adjusted by realtime modify (p. 19).
The indicator that at the upper right of the realtime modify knobs will
move from top to bottom. This is the same operation as pressing [SELECT].
PLAY/STOP: Play/stop the sequencer.
ROLL/HOLD: This turns the [ROLL/HOLD] (p. 16) on/off.
M-FX OFF/ON: This turns the multi-effects on/off.
REV OFF/ON: This turns the reverb on/off.
PATCH UP: In normal Play mode, this advances to the next patch number.
In Chain Play mode, this advances to the next chain step.
In Sequencer Play mode, this advances to the next pattern.
PATCH DOWN: In normal Play mode, this goes back to the previous patch number.
In Chain Play mode, this goes back to the previous chain step.
In Sequencer Play mode, this goes back to the previous pattern
number.