Roland HPD-15 - Manual (Page 55)

55
Chapter 2 Modifying a Patch
Chapter 2
Specifying the Roll Speed
You can specify the speed at which notes will be repeated
when you press [ROLL/HOLD].
fig.2-27
Roll Speed: 1.0–50, 1/2, 1/3, 1/4, 1/6, 1/8,
1/12, 1/16, 1/24, 1/32, 1/48
1–50 :
The selected number of notes will be repeated each
second.
1/2–1/48 :
The notes will be played at note value intervals relative
to the sequencer tempo (p. 27, p. 60).
Setting for MIDI
Transmission
For details, refer to p. 76.
Parameter Category: PAD MIDI
Note No. : OFF, 0:C - –127:G 9
Sets the MIDI note number that each pad will transmit. If you
select “OFF,” no MIDI note message will be transmitted.
Gate Time: 0.1–8.0sec
For each pad, you can specify the length of time the note will
“hold” during transmission from the MIDI OUT.
Naming a Patch
Each patch can be given a name ( Patch Name ) of up to 10
characters.
Parameter Category: PATCH NAME
fig.2-28.e
Use [ PARAMETER] or [PARAMETER ] to move
the cursor to left or right, and turn [PATCH/VALUE] to
select the desired characters.
Characters May Be Used in a Name
fig.2-29.e
U0101 FUNC
Roll Speed 20
U0101 PATCH NAME
[Conga _ ]
Cursor
ABCDEFGHIJKLMNOPQRSTUVWXYZ
abcdefghijklmnopqrstuvwxyz
0123456789!#$%&"’^‘_+-*/=
<>()[]{},.:;?@ ¥|
(Blank)