Roland HPD-15 - Manual (Page 59)

59
Chapter 3
Chapter 3 Recording Your Performance (Sequencer)
You can record your performance in the sequencer .
On the HPD-15, your performance will be recorde exactly as
you play it (
Realtime Recording ).
The HPD-15’s sequencer consists of four parts (Percussion 1,
Percussion 2, Melody 1, Melody 2). The collective
performance of these four parts is called a
pattern .
Preset patterns (pattern P01–P99)
What the various parts should play has already been
recorded.
User patterns (pattern U01–U99)
These are patterns that you can record.
Basic Settings for Recording
1. Press [SEQUENCER] to make it light; you will enter the
Sequencer mode.
fig.3-01.e
2. Turn [PATCH/VALUE] to select the user pattern for
recording your performance.
fig.3-02
3. Press [ PARAMETER] or [PARAMETER ] to
select the pattern/click parameter that you wish to set.
fig.3-03.e
4. Turn [PATCH/VALUE] to make settings for the pattern
or click.
fig.3-04.e
5. Press [REC] and you will enter the Recording Stand-by
Mode .
[PLAY/STOP] will blink.
fig.3-05.e
* If you press [REC] once again, you will return the previous
screen.
6. Press [ PARAMETER] or [PARAMETER ] to
select the recording parameter in the Recording Stand-by
Mode.
fig.3-06.e
7. Turn [PATCH/VALUE] to make settings for the
recording.
8. Press [PLAY/STOP] to start the recording.
While the recording, [PLAY/STOP] will light.
* It is possible to start/stop the recording by the foot switch (p.
71), but it is not possible by the D Beam or pedal (p. 53).
9. When you are finished recording, press [PLAY/STOP]
once again.
[REC] and [PLAY/STOP] will go dark, and the
recording will stop.
fig.3-07
10. Naming the pattern, press [WRITE].
How to naming a pattern is the same as naming a patch.
Refer to “Naming a Patch” (p. 55).
It is not possible to record to a preset pattern.
* To return to normal Play mode, Press [SEQUENCER] or
[EXIT]; [SEQUENCER] will go dark.
U01 001-01 =120
4/4 #User-001
Current Measure
Pattern Name
Pattern Number Tempo
Current Beat
U : User
P : Preset
Displayed for an
unrecorded pattern
Time
Signature
U07 001-01 =120
4/4 #User-007
U07 SETUP
Time Sig. 4/4
Parameter Value
Parameter Category
U07* SETUP
Length 8
Parameter Value
appears if this pattern is edited
U07*001-01 =120
RecStby Perc1
Part for Recording
U07*001-01 =120
RecMode Replace
Parameter Value
NAME[User-001 ]
Write Rec Data? _