Runco CW-50MC - Manual (Page 13)

SDTV-1 SDTV-2 DIGITAL IN
HDTV-2 PC/HDTV-1
POWER ASPECT
RATIO
RGB
SETUP
INFO
1 2
3 4
MENU MAGNIFY
SET
-
+
MUTE VOLUME
A
D
G
J
C
F
B
I
K
R
S
Q
P
E
H
L, M, N, O
REMOTE CONTROL DESCRIPTION
12
A. ASPECT RATIO
Press to change the aspect ratio or geometry of
the image. Different resolutions will allow for
different aspect ratios.
B. RGB SETUP
When entering a computer-type (VESA) signal,
press this to automatically center and resize the
image.
C. POWER
Press this to cycle the monitor between on and
standby.
D. PC/HDTV-1
Selects the 15-pin D-sub input for computer-type
(VESA) signals or HDTV signals.
E. HDTV-2
Selects the computer DVI input. (Input2)
F. INFO
While video is being displayed, this will bring up
timing information and input signal.
G. SDTV-1
Selects the first standard definition input, either
S-Video or Composite video based on the toggle
button, on Modular Controller card.
H. SDTV-2
Selects the second standard definition input, for
interlaced component video input.
I. DIGITAL IN
Selects the digital video from the DVI input. (Input5)
J. MENU
Activate or de-activate the menu.
K. MAGNIFY
Zooms in on the image, particularly useful for
computer-type (VESA) images.
L. UP
Scrolls the highlight bar in the menu up.
M. LEFT
Used for scrolling left, particularly during
adjustment menus.
N. RIGHT
Used for scrolling right, particularly during
adjustment menus.
O. DOWN
Scrolls the highlight bar in the menu down.
P. SET
Use for entering a sub-menu when selected by
high light.
Q. MUTE
Used to mute the sound system.
R. VOLUME -
Used to reduce the volume of the sound system.
S. VOLUME +
Used to reduce the volume of the sound system.
T. INSTALLER ADJUST - svc (pin hole)*
Used to access the INSTALLER ADJUST MENU.
Plasma Remote Control
T (svc)*