Runco CW-50MC - Manual (Page 18)

INPUT 3 INSTALLER ADJUST
PICTURE
GAMMA : 2.0
BRT. ENHANCE : OFF
SUB VOLUME : 20
WHITE BAL. SCREEN SET UP OPTION
INPUT 3 INSTALLER ADJUST
PICTURE
OSD
FRONT INDICATOR : OFF
FAN CONTROL
: AUTO
COLOR MODE : NORMAL
RUNCO PRO
FRC
: MODE1
WHITE BAL. SCREEN SET UP OPTION
INPUT 3 INSTALLER ADJUST
PICTURE
PDP PROTECTION
SCREEN MASK : OFF
SIDEBAR ADJ. : NORMAL
2x2 MODE : OFF
MIRROR MODE : OFF
BAUD RATE : 9600BPS
ID NO. SET : 01
FUNCTION DEFAULT
WHITE BAL. SCREEN SET UP OPTION
INSTALLER MENUS for VIDEO NTSC, PAL or ATSC
INSTALLER ADJUST Menus for Video NTSC, PAL or ATSC
17
4. SETUP Tab
• GAMMA is the relationship between pixel value and
displayed intensity.
• BRT. ENHANCE is used to enhance the black levels.
• SUB VOLUME is used to configure sub-woofer
levels.
5. OPTION Tab
• PDP PROTECTION allows for automatic switching
of the displayed image at regular intervals.
• SCREEN MASK is used for masking of source
material such as 16x9 or 4x3.
• SIDEBAR ADJ. is used specifically for masking in
4x3 or NTSC signals
• 2x2 MODE is used for video wall applications. Up to
4 plasmas can be linked in a 2x2 configuration with no
external processing.
• MIRROR MODE allows for a reflected image to be
shown from the plasma panel.
• BAUD RATE is the RS-232 port connectivity rate.
• ID. NO. SET is used for RS-232C daisy chaining of
the plasma.
• FUNCTION DEFAULT defaults to the factory
settings for all the functions within the input.
6. OPTION Tab (continued)
• OSD specifies if the On Screen Display is ON or OFF.
• FRONT INDICATOR allows for naming of the
display.
• FAN CONTROL should be set to AUTO for lowest
fan noise.
• COLOR MODE is used to select between NORMAL
and ISF mode. Once in ISF, values selected in WHITE
BAL. will be saved as settings in ISF. Once NORMAL
is chosen setting are defaulted.
• RUNCO PRO is for adjusting the underscan, setting
markers, enable or disable of color and specifying the
signal type.
• FRC is usually set to Mode1.
These menus will appear only when displayed for video.