Roland BR-864 - Manual (Page 63)

63
Using the loop effects/Track EQ
Section 1
Adjusting how the loop effect is
applied
The following explains how you can alter the volume of the
signals sent by each track to the loop effects (the send level),
and control the degree to which the loop effects are applied.
1. Press [LOOP EFFECTS].
2. Press CURSOR [ ] [ ] to move the cursor to “CHO/
DLY” or “REV,” and press [ENTER].
fig.01-705d
3. Press CURSOR [ ] [ ] to select the screen for setting
the send level of each track appears.
When using CHO/DLY
fig.01-706d
When using REV
fig.01-707d
4. Use [CURSOR] and the TIME/VALUE dial to adjust
the send level for each track.
* Pressing a REC TRACK button moves the cursor to the track
corresponding to the button pressed.
Pressing [TRACK] switches to between Tr1–4 and Tr5–8.
If you then press CURSOR [ ], the screen for setting
the input-source send level appears in the display; if you
press CURSOR [ ], the one for setting the rhythm
guide send level is displayed.
fig.01-708d
fig.01-709d
To adjust the send level for the input source, move the
cursor to “In Send.” To adjust the send level for the
rhythm guide, move the cursor to “Rhy Send.” The
setting is adjusted by turning the TIME/VALUE dial to
the desired value.
5. After you have completed adjusting the send level,
press [EXIT] repeatedly to return to the Play screen
You can switch screens in the following sequence, with
the screen cycling to the next screen each time [LOOP
EFFECTS] is pressed.
Loop Effects selection screen
→
Send Level screen
→
Type screen
→
Play screen