Dynamixel dx-116 – Robotis DX-116 User Manual

Page 15

Advertising
background image

14

English Translation by: Tribotix Pty Ltd

www.tribotix.com

DYNAMIXEL

DX-116

receive the requested Status Packet. The delay time is given by 2uSec *

Address5 value.

Address 0x06,0x07,0x08,0x09

Operating Angle Limit. Set the operating angle to restrict the Dynamixel’s angular range. The Goal

Position needs to be within the range of:-

CW Angle Limit <= Goal Position <= CCW Angle Limit

An Angle Limit Error will occur if this relationship is not satisfied.

Address 0x0B

the Highest Limit Temperature. The upper limit of the Dynamixel’s operative

temperature. If the Dynamixel’s internal temperature is higher than this value,

an Over Heating Error Bit (Bit 2 of the Status Packet) will be set. An alarm will

be set in Address 17,18. The values are in Degrees Celsius.

Address 0x0C,0x0D

the Lowest (Highest) Limit Voltage. Setting the operative upper and lower limits

of the Dynamixel’s voltages.

If the present voltage (Address42) is out of the specified range, a Voltage Range

Error bit will be set in the Status Packet and an alarm executed will be set in

Address’s 17,18. The values are 10 times the actual voltages. For example, if

the Address 12 value is 80, then the lower voltage limit is set to 8V.

Address 0x0E,0x0F, 0x22,0x23

Max Torque. The max torque output for the Dynamixel. When it is set to ‘0’,

the Dynamixel enters a Torque Free Run condition. The Max Torque (Torque

Limit) is assigned to EEPROM (Address 0X0E,0x0F) and RAM (Address

0x22,0x23) and a power on condition will copy EEPROM values to RAM. The

torque of a Dynamixel is limited by (Address0x22,0x23) of RAM.

Address 0X10

Status Return Level. To determine whether the Dynamixel will return the Status

Packet after the transmission of an Instruction Packet.

In the case of an instruction which uses the Broadcast ID (0XFE), regardless of

the Address 0x10 value, the Status Packet will not be returned.

Address16

Return of Status Packet

0

Do not respond to any instruction

1

Respond only to READ_DATA instructions

2

Respond to all instructions

Advertising