Roland AT90S - Manual (Page 184)

182
Chapter 10 Connecting with External Device
4. Turn on the computer.
5. Turn on the AT-90S/80S/60S.
6. Make the settings for baud rate (transmission
speed) for the computer and the software.
For more information on this procedure, please refer to the
owner’s manual for your computer.
7. You should also make the settings for the MIDI
send channel as needed (p. 174).
Connection Examples:
Connection with an Apple Macintosh computer
Use a computer cable (sold separately) to connect the
Computer connector on the AT-90S/80S/60S to the modem
port (or printer port) on the Apple Macintosh. Set the
Computer switch to “Mac.”
When using the Macintosh “Patch Bay” utility, specify 1
MHz as the Interface Type (MIDI Interface Clock).
Connection with an IBM PC
Use a computer cable (sold separately) to connect the
Computer connector on the AT-90S/80S/60S to the COM1 or
COM2 serial port on the IBM PC. Set the Computer switch to
“PC-2.”
Apple Macintosh
Macintosh IIci
Modem Port
Computer cable (sold separately)
Computer
PC-1
Mac
PC-2 MIDI
RS-232C
IBM PC/AT
Computer cable (sold separately)
Computer
PC-1
Mac
PC-2 MIDI