Roland AT90S - Manual (Page 25)

23
Before You Start Playing
The confirmation message appears on screen.
fig.00-40.eps
If you touch <Cancel>, the Factory Reset will not be
performed, and you will return to the System screen.
5. When you touch <OK>, the Factory Reset
operation will begin, and the settings will return
to the factory-set condition.
NOTE
Never switch off the power while this operation is in
progress!
fig.00-40.eps
NOTE
Loading factory default settings will erase any Registrations
currently in the memory of the AT-90S/80S/60S. To save the
registrations you are currently using, refer to
“Saving
Registration Sets to a Floppy Disk” (p. 84).
NOTE
If you want to restore the factory settings for only the
Rhythm [Disk] button and [World] button, refer to p. 70, 73.
You can also use the following method to return to the
factory-set condition.
1. Make sure there is no floppy disk in the disk
drive before carrying out the procedure.
2. Turn off the power.
3. While holding down the [One Touch
Program] button, press the [Power On] switch
to turn the power on.
fig.00-41
Hold down the [One Touch Program] button until
the following is displayed.
fig.00-40.eps
NOTE
Never switch off the power while this operation is in
progress!
Power On Program
One Touch
Set
Min
Max
Min
Max
Min
Max
Min
Max
Harmony Intelligence