Roland AT90S - Manual (Page 51)

49
Chapter 1 Selecting and Playing Sounds
1.
The volume levels of each part are adjusted using the
corresponding [▲] and [▼] buttons.
Pressing the upper button ([▲] button) will increase the volume.
Pressing the lower button ([▼] button) will decrease the volume.
The volume can be set to any value from 0 to 12.
When the volume value shown in the display is 0, that part will produce no
sound.
You can also press the [▲] button and [▼] button of the part whose volume
you wish to adjust, so that the “Part Balance Monitor screen” is displayed
for several seconds, allowing you to check the volume balance.
fig.01-27
You can check the volume by viewing the Level Balance indicators of each
part on AT-90S/80S.
fig.01-27-2
The Part Balance Monitor
screen is displayed for
several seconds and then
closes automatically.
If you touch <Hold>, the
screen continues to be
displayed until you touch
<Hold> again.
Sax Violin Trumpet
Flute
Oboe
Clarinet Level
Alternate To Lower
Solo
Min
Max
Min
Max
Min
Max
Min
Max
Harmony Intelligence