Roland AT90S User Manual

Page 6

Advertising
background image

4

015

• Do not force the unit’s power-supply cord to share

an outlet with an unreasonable number of other
devices. Be especially careful when using
extension cords—the total power used by all
devices you have connected to the extension
cord’s outlet must never exceed the power rating
(watts/amperes) for the extension cord. Excessive
loads can cause the insulation on the cord to heat
up and eventually melt through.

..........................................................................................................

016

• Before using the unit in a foreign country, consult

with your retailer, the nearest Roland Service
Center, or an authorized Roland distributor, as
listed on the “Information” page.

..........................................................................................................

For AT-90S/80S

022a

• Always turn the unit off and unplug the power

cord before attempting installation of the light
bulbs (p. 214).

101a

• The unit should be located so that its location or

position does not interfere with its proper venti-
lation.

..........................................................................................................

102b

• Always grasp only the plug on the power-supply

cord when plugging into, or unplugging from, an
outlet or this unit.

..........................................................................................................

104

• Try to prevent cords and cables from becoming

entangled. Also, all cords and cables should be
placed so they are out of the reach of children.

..........................................................................................................

106

• Never climb on top of, nor place heavy objects on

the unit.

..........................................................................................................

107b

• Never handle the power cord or its plugs with wet

hands when plugging into, or unplugging from,
an outlet or this unit.

..........................................................................................................

108d: Selection

• If you need to move the instrument, take note of

the precautions listed below. At least two persons
are required to safely lift and move the unit. It
should be handled carefully, all the while keeping
it level. Make sure to have a firm grip, to protect
yourself from injury and the instrument from
damage.

1

• Check to make sure the bolt securing the unit to

the stand have not become loose. Fasten them
again securely whenever you notice any
loosening.

2

• Disconnect the power cord.

3

• Disconnect all cords coming from external

devices.

5

• Close the lid.

7

• Fold down the music stand.

..........................................................................................................

109a

• Before cleaning the unit, turn off the power and

unplug the power cord from the outlet (p. 19).

..........................................................................................................

115a

• Install only the specified light bulb(s). Remove

only the specified screws (p. 214).

..........................................................................................................

116

• Be careful when opening/closing the lid so you do

not get your fingers pinched (p. 18). Adult super-
vision is recommended whenever small children
use the unit.

..........................................................................................................

117: Selection

• When using the bench, please observe the

following points:

1

• Do not use the bench as a toy, or as a stepping

stool.

2

• Do not allow two or more persons to sit on the

bench.

4

• Do not sit on the bench if the bolts holding the

bench legs are loose. (If the bolts are loose,
immediately re-tighten them using the supplied
wrench.)

5

• When opening or closing the seat lid, be careful

not to pinch your fingers. In particular, be
careful not to pinch your fingers in the folding
metal supports (p. 22).

..........................................................................................................

For AT-90S/80S

118

• Should you remove screws and light bulbs, make

sure to put them in a safe place out of children’s
reach, so there is no chance of them being
swallowed accidentally.

..........................................................................................................

Advertising
This manual is related to the following products:

80S, 60S