RAD Data comm ASM-60 - Manual (Page 10)

Chapter 1 Introduction ASM-60 Installation and Operation Manual
1-2 Overview
Table 1-1. Typical ASM-60 Ranges
Data Rate 24 AWG
(Mbps) km miles
4.096 2.0 1.2
6.144 2.0 1.2
10.24 1.8 1.1
DTE Interface
The ASM-60 DTE interface supports the following interfaces:
• HSSI
• IR-ETH module with built-in Ethernet bridge
• IR-ETH/QH module with built-in Fast Ethernet bridge and VLAN support
• IR-IP module with built-in IP router.
Management
Setup, control, monitoring of status and diagnostics can be performed using an
ASCII terminal connected to the ASM-60 async DCE control port.
Test Capabilities
ASM-60 performs an extensive self-test at start-up. During the self-test, ASM-60
checks its CPU, internal framer, DTE and interfaces and power supplies. The
self-test results are displayed on the supervisory terminal.
Real Time Alarms
Real time alarms provide real time information on system status indicating loss of
synchronization on line A and line B, DCD status etc.
ASM-60 also features a log file that stores all alarms and events that occurred in the
unit. These alarms can be displayed and cleared.
Statistics Collection
ASM-60 stores the VDSL statistics for the line performance monitoring.