RAD Data comm ASM-60 - Manual (Page 6)

Quick Start Guide ASM-60 Installation and Operation Manual
2 Configuring ASM-60
2. Operating ASM-60
Normal Indications
The table below shows the correct status of the indicators a few seconds after
power-up.
Indicator Status
PWR ON
TD Depends on DTE data transmission.
RD Depends on DTE data transmission.
RTS Depends on DTE RTS signal status.
DCD Depends on remote modem data transmission.
TEST OFF
ALM OFF
SYNC A/SYNC B Green or red, depending on remote modem data
transmission.
3. Configuring ASM-60
Configure ASM-60 to the desired operation mode via an ASCII terminal using the
embedded management software. Configuration of the ASM-60 modem includes
selection of a data rate.
Selecting the Data Rate
➤ To select the data rate:
1. From the Configuration menu, type 1.
The Data Rate menu appears.
2. Select the data rate by typing the number corresponding to the desired value
and then type 2 to save the changes.
Main Menu
↓↓↓↓ 1
Configuration
↓↓↓↓ 1
Data Rate