RAD Data comm ASM-60 - Manual (Page 55)

ASM-60 Installation and Operation Manual Appendix C IR-IP Interface Module
Quick Setup Menu C-11
IR_IP <IR-IP> S/W Ver. 1.00 31/IR (date)
Quick Setup
=====================================================================
1. LAN IP Address :192.168.100.001
2. LAN IP Mask :255.255.255.000
3. WAN IP Address (empty for unnumbered) :...............
4. WAN IP Mask (empty for unnumbered) :...............
5. Default Gateway (empty - WAN interface) :...............
6. Read Protocol From DIP Switches :[ Yes ]
7. Protocol :[ Frame Relay ]
Press one of the numbers to select or ESC:
Figure C-6. Quick Setup Menu
LAN IP Address
Used to enter the IP address for the IP router LAN interface. This is the address to
which nodes connected to the local LAN send packets addressed to the WAN.
LAN IP Mask
Used to enter the IP subnet mask. The IP router supports a maximum of 254 hosts
on the LAN, therefore you must use Class C subnet masks. The basic subnet IP
mask for Class C addresses, which supports the maximum possible number of
hosts, 254, is 255.255.255.0. To help you understand the selection of IP subnet
masks, Figure C-7 provides a configuration example for a LAN with 6 nodes: the IP
subnet mask for a 6-node IP network is 255.255.255.248.
ASM-60 with IR-IP
.6 .5 .4 .3 192.168.1.2
LAN IP Address: 192.168.1.2
IP Address
.248 .248 .248 .248 255.255.255.248
Mask: 255.255.255.248
Mask
192.168.1.1 192.168.1.1 192.168.1.1 192.168.1.1 192.168.1.1 Default Gateway
Figure C-7. Selecting the IP Subnet Mask
WAN IP Address
Used to enter the IP address for the IR-IP WAN interface, i.e., the IP address to be
used by IP hosts on the WAN to reach this IR-IP interface module.
If the WAN IP Address field remain blank, IR-IP operates in the Unnumbered
Router Mode.
WAN IP Mask
Used to enter the IP subnet mask for the WAN interface.