ResMed Flow Generator VPAP Adapt SV - Manual (Page 14)

14
ResLink™
The ResLink is a device that records data onto a SmartMedia™ card during your
therapy. The card can be returned to your clinician so that they can observe your
progress and adjust flow generator parameters if necessary. The ResLink
connects to the back of VPAP Adapt SV as shown. For full details on using the
ResLink, please refer to the ResLink User’s Manual.
Anti-bacterial Filter
Your clinician may recommend that you use an anti-bacterial filter. A filter should
be placed in the air tubing between the mask and the flow generator. If using a
humidifier, place the filter between it and the flow generator (see Figure 10
below).
Typically, the filter should be replaced daily. Check the filter instructions for full
details.
Whenever a filter is added, removed or replaced you must run the Air Circuit
Learn function (see “Learn Circuit” on page 21).
Note: Only hydrophobic anti-bacterial filters should be used with a
HumidAire 2i.
Figure 10: Inserting anti-bacterial filters
Anti-bacterial filters
228234 VPAP Adapt SV User Guide USA Eng.book Page 14 Monday, October 13, 2008 2:15 PM