Rowe CD-100K User Manual
Page 158
Section 3: Routine Service
221822666
3 - 5
5. Repeat Step 4 until all discs have been changed.
6. Release the two catches holding the keyboard/display.
7. Place the SERVICE switch in the SERVICE mode and check that * SERVICE MODE * is on the keyboard
display.
8. Type 31 and the display will show PROGRAM INIT - -. Enter the CD numbers that you have changed and
press POPULAR after each number. After you have entered all of the disc numbers, place the phonograph
into the NORMAL mode and the initialization process will start. Selections can be made while the new discs
are being initialized.
NOTE:
When loading the magazine, be sure the disc rests in the same numbered slot in both
the front and rear of the magazine. Be sure to keep the magazine disc load approxi-
mately balanced. If the magazine is partially loaded with all discs on one side, the
sprag wheel may lock and the magazine will not turn.