Rowe CD-100K - Manual (Page 29)

CD-100K Phonograph
2 - 4 21822666
PROCEDURES FOR LOADING THE TITLE PAGE HOLDER
1. Tear each title strip from the title sheet so the perforated column appears on the side of the title strip. (The
shaded portion of the title strip in Figure 2-1 represents a title strip that has been removed from the title sheet).
2. Fold the title strip along the perforated line on both sides of the title strip (see Figure 2-2).
3. Locate the CD album booklet that matches the title strip you have just made. If the CD booklet is more than
two sheets thick, remove the inner sheets so that the booklet is no thicker than two title strips.
Figure 2-3. Loading the Title Page Holder
(2 of 6 Pages Shown)
Figure 2-2. Folding the Title Strip
4. Insert the CD booklet under the top and bottom tabs of the title page. Slide the CD booklet over until the it
is trapped by the molded stops on the title page holder (see Figure 2-3, Ref. A).
5. Insert the folded title strip under the top and bottom tabs of the title holder. Slide the title strip until the disc
number shows in the opening of the title strip and the title strip is locked in place by the molded stops (see Figure
2-3, Ref. B).
6. All of the tabs surrounding the CD booklet and title strip should be holding them in place. If you missed a tab,
carefully tuck the loose paper under the tab as shown in Figure 2-3, Ref. C.
7. Repeat Steps 4 and 5 until all titles are installed. Use the page keys switch (Figure 1-5) to change title pages.
Insert filler title strips to fill out any unused space left on a page. Insert these in the same way that you installed
the fill-in title strips.
A
B
C
Tabs
DIS C NO
.
FIR ST
2 D IG ITS
Title Strip
CD Booklet