Rowe CD-100K User Manual
Page 18
Advertising
Section 1: Installation & System Description
221822666
1 - 5
Save all shipping hardware that you remove in the following six steps:
Mechanism
CD UNPACKING
1. Remove the CD changer mechanism shipping bolt from the back of the phonograph cabinet
(see Figure 1-3).
Figure 1-3. Shipping Bolt Removal
2. Remove the shipping tape from the front ends of the mechanism tie-down levers on the side of the mechanism
frame (see Figure 1-4).
3. Push the end of the lever down slightly, rotate the lever away from the frame until the latch tab clears the hole
in the frame, rotate the lever up until the mechanism is free, and remove the levers.
Figure 1-4. CD Changer Tie-Down Screws
Tie-Down Bolt
Mechanism Frame
Advertising