2 dhd controller front panel, Figure 2-5 . dhd controller front panel, Dhd controller front panel – Runco PLASMAWALL XP-OPAL65DHD User Manual
Page 24: 5. dhd controller front panel, Pre l iminar y
8
PlasmaWall XP Series Installation/Operation Manual
PRE
L
IMINAR
Y
1.
SLOT 1
Not used.
2.
SLOT 2 (Dual HDMI input)
Two, HDCP-compliant digital video inputs. Connect the HDMI output from the
DHD Controller to input “A” in this slot.
3.
SLOT 3 (COMPONENT/RGB input)
Not used.
4.
PC IN
Not used.
5.
RS-232C (9-pin, male D-Sub)
Connect the Display Control (RS-232 OUT) port on the DHD Controller to this input.
6.
POWER INPUT
Connect the PlasmaWall to AC power here.
2.2
DHD Controller Front
Panel
Figure 2-5 shows the controls and indicators on the DHD Controller front panel; the
paragraphs that follow describe them.
Figure 2-5. DHD Controller Front Panel
1.
RUNCO ICON
Lights blue to indicate that the controller is on or powering up.
2.
IR SENSOR
Receives IR commands from the remote control.
3.
VACUUM FLUORESCENT DISPLAY
Can be used instead of the On-Screen Display (OSD). Displays currently-selected
menu or – if no menu is selected – the connected display device model, current
source, input resolution and aspect ratio.
4.
ON/STANDBY BUTTON
Press once to toggle from standby mode to on mode. Press it again to return to
standby mode. For a discrete on or off command, you can use the direct access
buttons on the remote control.
ratio
ratio
i
n
p
u
t
standby
m
e
n
u
i
n
p
u
t
enter
3
HDMI
1
16:9 1080i/60
3
1
9
10
11
6
5
4
8
7
2
XP-50DHD