Installation, 1 remote control, Notes on batteries – Runco PLASMAWALL XP-OPAL65DHD User Manual
Page 31: Notes on remote control operation, Figure 3-1 . available range of the remote control, Remote control, 1. available range of the remote control, Pre l iminar y
PlasmaWall XP Series Installation/Operation Manual
15
PRE
L
IMINAR
Y
3.1
Remote Control
To install batteries in the remote control:
1.
Press down the tab on the cover and
pull the cover in the direction of the
arrow.
2.
Insert the included batteries. Ensure
that the polarities correctly match the
and
markings inside the battery
compartment.
3.
Insert the lower tab of the cover into the
opening, and press down the cover until
it clicks in place.
Notes on Batteries
• When installing batteries, make sure that the battery polarities are correct.
• Do not mix an old battery with a new one or different types of batteries.
• If you will not use the remote control for a long time, remove the batteries to avoid
damage from battery leakage.
Notes on Remote Control
Operation
The remote control can be used to control the PlasmaWall within the ranges shown in
Figure 3-1.
Figure 3-1. Available Range of the Remote Control
3. Installation
ratio
ratio
i
n
p
u
t
standby
m
e
n
u
i
n
p
u
t
enter
3
HDMI
1
16:9 1080i/60
CUST
1
CUST
2
SVC
HDMI
1
HDMI
2
EXIT
RETURN
16 : 9
4 : 3
Approx.
40 feet
(12.2 meters)
Approx.
30º
Approx.
30º