Omron Programmable Terminals NT631C - Manual (Page 294)

277
Appendix I
Relationship between system program and
hardware
Here, relationship between system program and hardware is described.
System programs indicated below are installed for the models shown above in the default state. Also, system
programs are supplied with the Support Tool as follows.
Note NT System Installer version 2.0 or higher is required to transfer the NT631-EV3-compatible system pro-
gram. (NT System Installer version 2.0 is provided with the NT-series Support Tool version 4.08 or
higher.)
These system programs have mutual compatibility, therefore, they can be installed and used for NT631-
ST211
@-E /NT631C-ST141 -E /NT631C-ST151 @-E , NT631-ST211 @ -EV1/NT631C-ST141 @ -EV1/NT631C-
ST151 @ -EV1, and NT631-ST211 @ -EV2/NT631C-ST141 @ -EV2/NT631C-ST151 @ -EV2/NT631C-ST152 @ -EV2
each.
However, there will be a limitation on function depending on the combination. Refer to the following table.
System program version 4.0 @ is only for NT631C-ST153 @-EV3 . The system program cannot be installed in
pre-version-2 hardware. System program earlier than Ver. 3.1 @ cannot be installed in NT631C-ST153 @-EV3 .
The following table shows only the relationship between the hardware and system program.
For details of the relationship with the screen data created using the Support Tool, refer to NT-series Support
Tool for Windows (Ver. 4.@) Operation Manual (V061-E1-
@ ).
Model History System program
NT631-ST211 @-E Conventional product System Program version 1. @
(supplied with the
NT-ZJCMX1-EV2)
Same for pre-version-1 and
version-2 hardware, but
there are restrictions to
some functions depending
on the hardware version that
is installed.
NT631C-ST141 @-E
NT631C-ST151 @-E
NT631-ST211 @-EV1 Version upgrade of the
above products
(December 1998) System Program version
2.0
@ or 2.1@
(supplied with the
NT-ZJCMX1-EV3)
NT631C-ST141 @-EV1
NT631C-ST151 @-EV1
NT631-ST211 @-EV2 Version upgrade of the
above products
(December 1999) System Program version
3.0
@ or 3.1@
(supplied with the
NT-ZJCMX1-V4.00)
NT631C-ST141 @-EV2
NT631C-ST151 @-EV2
NT631C-ST152 @-EV2 Version upgrade of the
above products
(October 2004) System Program version
3.1
@
(supplied with the
NT-ZJCMX1-V4.05)
NT631C-ST153 @-EV3 Version upgrade of the
above products
(September 2006) System Program version
4.1
@
(supplied with the
NT-ZJCMX1-V4.08)
Only for hardware for ver-
sion-3 (EV3) PTs. Cannot be
installed with pre-version-1
or version-2 hardware.