Oki 87 - Manual (Page 46)

34 OKIOFFICE 87 User’s Guide
7 Enter the Location ID. This is a descriptive title up to 15 characters
long. Refer to the instructions below.
To Do This Use
Enter numbers Numeric keypad (press once)
Enter spaces SPACE One-Touch key
Enter hyphens HYPHEN key
Enter alphabet characters Locate the character you want on the numeric keypad.
Press that key repeatedly until the character appears.
Enter a unique character Press the 0/UNIQUE key repeatedly until the character
you want appears.
The following characters are available: ! @ \ “ _ % ~ # &
‘ ( ) * + , - . / : ; = ? · д Я с ц ь Ж Е Ш ж е ш.
Note: Some unique characters can be entered using
One-Touch keys.
Enter two letters using Press NO to move to the next character.
the same key.
Move the cursor to YES and NO
make corrections.
8 Press the START key. The display shows NO=<OR LOCATION>.
9 Enter the alternate fax number. Refer to the instructions following
Step 5.
10 The display shows G3 COMMUN. SPEED [33.6K]. Press
NO
to adjust the speed and
YES
to select it.
11 The display shows G3 ECHO PROTECTION [ON]. Press
NO
to change the setting and
YES
to select it.
12 Press the START key to finish programming the One-Touch key.
The display shows LOCATION PROGRAMMING.
13 To continue programming One-Touch keys, go back to Step 3. If you
are finished programming, press the SELECT FUNCTION key.
14 Lift off the plastic cover above the One-Touch label. Using a pencil,
write in the name for your newly programmed One-Touch key. Then
replace the cover.