Oricom S6000 - Manual (Page 13)

• Use to select SAVE ENTRY. Press .
• The display will show NAME?.
• Use the numeric keys & the key to enter the name.
• Press to confirm. The redial number will be displayed.
• Edit the number by using the numeric keys & the key.
• Press to confirm the entry.
• If the new entry would have the same name as a previously
entered record in the phonebook, the prompt ‘REPLACE?’ will
be displayed. Press , the number of the record in the
phonebook record with the same name will be replaced with
the new number.
• Press to return to standby.
Delete a Redial Number
• Press , the last number dialled will be displayed.
• Use to scroll through the last 10 dialled numbers.
• Press on a selected number.
• Use to select DELETE. Press .
• The display reads DELETE?. Press . The selected
number will be deleted.
• The display will return to the redial list.
• Repeat the above steps to delete another dialled number.
• Press to exit the redial list.
Note: Refer to Delete All Records section to delete the entire redial
log at once.
Making 2 nd External Call
This is a network dependent feature.
• During a call, press will put the current external call on
hold. Dialling tone for the 2 nd call can be heard.
• Enter the number you want to dial out by using the keypad.
• When the 2
nd call is answered, press to toggle between
the two callers or activate a conference call with two external
parties.
Inserting Pause for PBX System
User can press and hold to insert a Pause of 3 seconds. A “
will be shown on the display.
Note: If there is a in the predial, phonebook, redial or service
number, the handset will pause for the pre-programmed duration
before dialling out the next digit.
Receiving External Calls
When receiving an external call, all handsets including the base unit will
ring, provided that the ringers are on. The
icon on the display will
blink. The LED on the handset and the In Use LED on the base unit will
also blink.
When the handset is on the base unit, lift the handset:
• to answer the call when the AUTO ANS feature is turned on.
• press to connect the call if the AUTO ANS feature is
turned off. (Refer to section “Auto Answering” for details)
When the handset is not on the base unit:
• Press to connect the call.
13 of 42