Oricom S6000 - Manual (Page 39)

39 of 42
• You can exit the conference call by pressing on the hands
or place the handset on the cradle. The o her ha set and the
et
t nd
external call will still be connected. The and icons will be
turned off.
When more than one handset is registered to the same base unit, one
ts can be used as a room (baby) Monitor device.
Room Monitoring
of the handse
To activate:
• Press . Use to select FEATURES.
• Press . Use to select MONITOR.
• Press . Use to select ON.
• Press to confirm.
MONITOR will flash on the display to indicate the handset is in monitor
mode during standby. User can make internal call to this handset from
anoth
dset, the microphone on this handset is activated (being in
monito ode) and noise from the room can be heard. User can also
er han
r m
press to hear from the speaker. There will be no internal ringing.
e
To de-activat :
• Press will take you to the MONITOR menu directly.
• Press . The display reads ON.
• Press to select OFF.
• Press to confirm.
ote: The handset under monitor mode will not ring when an external
call comes in.
set can de-register all other handsets registered to the same
base unit.
• Press
N
De-register a Handset
One hand
. Use to select SYSTEM.
• Press . Use to select DELETE HS.
. • Press
Use to select the desired handset (HANDSET 1 to HANDSET
e
•
5) to be d leted.
• Press to confirm the selection. The display will rea PIN?.
Enter the correct PIN of the connecte
d
• d base and press to
confirm the deletion of the handset.
ote: Each handset can’t de-register itself. N