Oricom S6000 - Manual (Page 21)

21 of 42
• Press . Use to select between ON or OFF.
Setting up the Service Centre
st
therwise you can
not send a text message. However you should be aware that this will
allow presentation of your phone number to the called party.
the base unit is tryin connection with the service
centre, the active service centre number will be used. However,
m ervi ed.
Press
•
To assist in set up the service centre numbers have been pre-
programmed. These should not need to be changed.
SMS Centre 1 “183201983391”
SMS Centre 2 “01983391”
IMORTANT NOTE:
If you normally have your Calling Number display blocked you mu
remove 1832 in front of 01983391 in the SMS centre o
When
g to make a
messages fro any s ce centre can be receiv
. Use to select SMS.
• Press . Use to select SETTINGS.
• Press . Use to select SMSC.
• Press . Use to select between SMS CENTRE 1 and SMS
CENTRE 2.
• Press to confirm.
ice Centr
Numbers for two service centres can be entered and one of them will
be selected as the active service centre for outgoing messages.
•
Setting the Serv
e Number
Press . Use to select SMS.
• Press . Use to select SETTINGS.
• Press . Use to select SMS CENTRE1 or SMS
CENTRE2.
• Press .
• The display will read NUMBER? and the previously entered
umber will be displayed.
Enter/edit the service centre number. Maximum of 18 digits can be
ntered.
n
•
e
• Press to confirm.
If there is no Service Centre number for the selected Service
Cent
Note:
re, SC NOT READY will be displayed when is pre
to enter SMS menu or
ssed
is being pressed and held from
standby.
Since the Service Centre
override the CLIR, 18
must recognize your CLI, the prefix to
32, has already been added in the factory
apply to
all.
Sub address identifies each SMS-enabled device on the same
e. efau it doesn't need to be
e are bled phones
connected to the same line. When a call from Service Centre comes
ph with intende wer the call.
programmed SMS centre 1 number. This prefix does not
any other calls.
To remove this prefix from the SMS centre 1 number is not
recommended as the Service Centre may not recognize your c
Setting up the Sub-Address
telephone lin The d lt sub address is 0 and
changed unless ther more than one SMS-ena
in, only the one d sub address will ans
♦ Press . Use to select SMS.