Oricom PIX2000 - Manual (Page 15)

13
Operation and setup of the cordless handset
Operation and setup of the cordless handset
How to make a Call
1. Press the or key, wait for a dial tone, then dial the desired
number.
2. After finishing the conversation, press key or place the cordless
handset into the charger.
The talk timer will be shown for about 2 seconds before returning to
standby mode.
Pre-dialling
1. When the handset is in standby mode, input the desired number.
2. Press key to cancel the wrong digit, input the correct digit again.
3. Press the or key, the number will automatically dial out.
4. After finishing the conversation, press key or place the cordless
handset into the charger.
The talk timer will be shown for about 2 seconds before returning to
standby mode.
How to Adjust the Receiver or Speaker Volume.
While the phone is in talk mode, press or key on the handset
to adjust the receiver or speaker volume of the handset. There are 5
possible volume selections for handset speaker and recveiver. The display
will show the current volume level during adjusting.
How To Answer a Call
When the phone rings, the icon will fl ash and the LCD on the handset
will show “CALL”. If you have subscribed to Caller ID service from your
network service provider, the incoming call information will be shown.
1. Press the or key to answer a call.
2. After finishing the conversation, press key or place the cordless
handset into the charger.
PIX2000 User Guide.indd 章节2:13 PIX2000 User Guide.indd 章节2:13 2009-6-30 17:33:32 2009-6-30 17:33:32