Oricom PIX2000 - Manual (Page 61)

59
Troubleshooting
Troubleshooting
Problem Possible cause(s) Solution(s)
No dial tone on
the cordless
handset. 1. The base unit is not
properly connected.
2. Too far from the base unit.
3. Battery charge is low.
4. Incorrect battery polarity.
5. Re-register handset.
1. Check CONNECTION to
power and telephone line.
2. Move handset CLOSER to
base unit.
3. CHARGE battery.
4. RE-INSERT batteries and
check + and .
5. Handset not registered.
Antenna symbol
is fl ashing. 1. The handset is not
registered. If the handset
is unregistered, it displays
UNREGISTERED.
2. The handset is out of
range.
3. The product is not properly
connected.
1. REGISTER the handset.
2. Move CLOSER to the base
unit.
3. Check power
CONNECTION to the base.
No beep when
the cordless
handset is
placed on the
charger. 1. The handset is not placed
properly on the charger.
2. Charging contacts are
dirty.
3. No power connection to
base unit.
4. The handset’s power is
turned off.
1. Lift handset off the
charger carefully and
REPOSITION correctly.
2. CLEAN charging contacts
with a clean and dry cloth.
3. Check power
CONNECTION to the base.
4. CHECK batteries.
Handset
charged for
24 hours but
Battery icon
remains empty. 1. Handset battery is
defective or faulty.
2. Handset is not placed
properly on the charger.
3. Battery installed incorrectly.
4. The product is not properly
connected.
1. REPLACE with new AAA
rechargeable Ni-MH
batteries.
2. CHECK to make sure the
battery icon is scrolling.
3. RE-INSERT batteries and
check + and .
4. Check power
CONNECTION to the base.
PIX2000 User Guide.indd 章节2:59 PIX2000 User Guide.indd 章节2:59 2009-6-30 17:33:39 2009-6-30 17:33:39