Oricom PIX2000 - Manual (Page 8)

6
Getting Started
Installation of the Telephone Base and handset
1. Connect the mains adaptor (supplied) to the socket on the back of the
base unit and to the wall mains supply.
2. Connect the telephone cord to the phone socket on the back of the
base unit and into the wall phone socket.
3. Insert 2 rechargeable Ni-MH AAA batteries (included), observing the
correct polarity, into the battery compartment on the handset. Slide the
battery door fi rmly into place.
4. Place the handset on the charging cradle and charge the batteries for
a full 14 hours before using it for the fi rst time.
Note:
It may take some time for the cordless handset to power up, and it
may get warm during initial charge. This is normal.
Tip!
It is good practice to put the cordless handset on the charging cradle
when it is not in use to ensure that the handset is always fully charged.
Installation of the Photo Frame
1. Insert the supplied power adaptor into the socket on the bottom of the
Photo Frame.
PIX2000 User Guide.indd 章节2:6 PIX2000 User Guide.indd 章节2:6 2009-6-30 17:33:30 2009-6-30 17:33:30