Oricom PIX2000 - Manual (Page 32)

30
Note:
If the value you input is over the range during setting, you can’t enter
the next setting, please enter the correct setting again.
Registration
Register new handsets on the pix2000 base
The handset which comes with this pack is already registered to the
base. If you buy new handsets. You need to register them before use.
Up to 6 cordless handsets can be registered to one base.
1. Press key.
2. Press or key to select “REGISTRATION” and press key.
3. Press or key to select “REGISTER” and press key,
Press or key to select a base and press key, the LCD
will display “ENTER PIN”.
4. Input the correct PIN code and press key to begin to register the
cordless handset, the LCD will display “SEARCHING”.
5. Press and hold the page key for about 15 seconds.
Note:
1. “SUCCESSFUL” will be show on the handset LCD display if the
handset is registered to the base. Cordless handset number will be
shown after it returns to standby mode.
2. “FAIL” will show on the handset LCD display if the cordless handset
failed to register to the base, register the handset again.
Select Base
This option allows you to select a base.
1. Press key.
2. Press or key to select “REGISTRATION” and press key.
3. Press or key to select “SEL BASE” and press key, Press
or key to select a specifi c base or Auto.
Menu Operation
PIX2000 User Guide.indd 章节2:30 PIX2000 User Guide.indd 章节2:30 2009-6-30 17:33:34 2009-6-30 17:33:34