Onkyo TX-L55 - Manual (Page 51)

51
Advanced Setup —Continued
Setting the Audio Input Format
Setting the Digital Input Format
Normally, the TX-L55 detects the format of digital audio
signals automatically. However, if you experience either
of the following issues when playing PCM or DTS mate-
rial, you may need to specify the format yourself:
• With PCM material, if the beginnings of tracks are cut
off, try setting the format to PCM.
• With DTS material, if noise is produced when fast for-
warding or reversing, try setting the format to DTS.
Input Source Audio Setup
1 Use the INPUT SELECTOR but-
tons to select the input source
that you want to set.
2 Press the REMOTE MODE [AMP]
button followed by the [SETUP]
button.
3 Use the Up and Down [ ]/[ ]
buttons to select “4.Input Set,”
and then press [ENTER].
4 Use the Up and Down buttons to
select “Audio,” and then use the
Left and Right [
]/[ ] buttons to
select:
Auto: The assigned digital input
(page 31) has priority over the
input source’s analog input. If
no digital signal is present,
the analog input is used.
Multi: The DVD multichannel input
is used.
Analog: The input source’s analog
input is used even if a digital
signal is present at the
assigned digital input.
5 Press the [SETUP] button.
The setup menu closes.
TV AUX TUN
DVD V1
INPUT SELECTOR
V2
AMP
TUNER
ENTER
ENTER
1 Use the INPUT SELECTOR but-
tons to select the input source
that you want to set.
2 Press the REMOTE MODE [AMP]
button followed by the [SETUP]
button.
3 Use the Up and Down [ ]/[ ]
buttons to select “4. Input Set,”
and then press [ENTER].
4 Use the Up and Down buttons to
select “Format,” and then use the
Left and Right [
]/[ ] buttons to
select:
All: PCM, Dolby Digital, and DTS for-
mats are detected automatically. If no
digital signal is present, the input
source’s analog input is used.
DTS: Select this option if playing DTS
sources with the All option produces
noise while the TX-L55 identifies the
signal format or when fast forward or
fast reverse is used. If the input signal is
not DTS, nothing will be output.
PCM: Select this option if playing a
CD or other PCM source with the All
option causes the tops of tracks to be
cut off. If the input signal is not PCM,
nothing will be output.
TV AUX TUN
DVD V1
INPUT SELECTOR
V2
AMP
TUNER
ENTER
ENTER