Onkyo DX-R700 - Manual (Page 24)

24
Synchronous recording
DUAL DIGITAL INPUT
ANDBY ST
OFF ON
STANDBY/ON
POWER
AUDIO CD RECORDER DX-R 700
MEMORY CLEAR
REPEAT FINALIZE
STOP PLAY PAUSE
REC
PHONES LEVEL
MIN MAX
PHONES
YES
INPUT DISPLAY
EDIT/ NO
PUSH TO ENTER
MULTI JOG
STANDBY/ ON OPEN / CLOSE
RANDOM MEMORY REPEAT
NAME ABC DEF
2 3 1
SCROLL GHI MNO J K L
4 5 6
CLEAR
DISPLAY ENTER
PQRS TUV W XYZ
10/0 >10
7 8 9
REC o REC
o REC
INPUT
1
Repeatedly press the INPUT button
until “Digital In 1” or “Analog In”
appears.
When you connect the DX-R700 to other Onkyo
products using z cable, you can use the following
recording mode.
• Synchronous recording from the CD player to
the DX-R700.
• Synchronous recording from the MD recorder to
the DX-R700.
INPUT
• For digital recording from the CD player,
select “Digital In 1.” For analog recording,
select “Analog In.”
• For recording from the MD recorder, select
“Analog In.” If you select “Digital In 1” or
“Digital In 2” for this case, the synchronous
recording function is disabled.
• In any recordings above, selecting “Digital In
2” will disable the synchronous recording
function. In this case, use the signal
synchronous recording function instead (see
page 22).
• Proceed to step 3 if you do not wish to
adjust the recording level.
2
Press the play button on the source
device to start the playback.
or
Synchronous recording to the
DX-R700
Preparation
• Turn on the DX-R700 (see page 16).
• Prepare the source device for playback. (Load
the MD or CD into the MD player or the CD
player respectively.)
• Place a recordable CD-R or CD-RW in the DX-
R700 (see page 17).