Onkyo DX-R700 - Manual (Page 25)

25
REC
REC
DX-R700 RC-448C
Synchronous recording
4
Adjust the recording level.
Refer to page 21, step 4 “Adjust the recording
level.”
5
Stop the playback of the source device.
6
Press the play button on the source
device to start the playback.
Playing starts and recording starts at the DX-
R700.
When the playback finishes
Only when you perform the digital synchronous
recording from the CD player, the DX-R700 will go
into the recording standby state. After the recording
standby state lasts 10 minutes, the DX-R700 will
stop automatically.
In any other recordings, you will have to stop the
recording manually using the e STOP button on the
DX-R700.
To stop the synchronous recording
Press the e STOP button on the DX-R700. When
you are performing the digital synchronous
recording from the CD player, the stop of the CD
playback will cause the DX-R700 to enter the
recording standby state.
While performing analog recording, do not switch
the input selector control on the amplifier.
“Rec Setup” appears in the display followed by
the time display (the recording standby state).
Proceed to step 6 if you do not wish to adjust
the recording level.
3
Press the o REC button.