Onkyo DX-R700 - Manual (Page 44)

44
Troubleshooting guide
Messages during recording (continued)
Display Cause Remedy
Pro Disc A CD-R or a CD-RW not for music recording use Eject the disc and check whether it meets
(without the “FOR CONSUMER” marking) the specifications for use with the
or a CD-RW has been inserted. DX-R700. Always insert a disc that has
the markings “FOR CONSUMER” or “FOR
MUSIC USE ONLY” on its surface
(see page 12).
Check Input Synchronous recording cannot be Record from a recordable source.
performed because the detected input
signal is from a source other than the CD,
MD, DAT, or DCC.
Cannot Rec Recording cannot be performed because Replace it with a non-finalized CD-R.
a finalized CD-R is used.
Recording cannot be performed because Replace it with a non-finalized CD-RW. Or, retry
a finalized CD-RW is used. recording after unfinalizing it.
Messages during playback, name input, and other situations
Display Cause Remedy
Blank Disc You have tried to play a disc that has If the inserted disc is a CD-R or CD-RW
no recordings on it. with no recordings, you may record onto it,
but it cannot be played.
No Disc No disc has been inserted. Open the disc tray and make sure that a
disc is inserted.
Name Disc Finalizing a disc without disc name was Enter a disc name before attempting finalization
attempted. (see pages 28, 33).
Name Full Entering name information exceeding the You can enter up to 1000 characters per disc
limitation of 1000 characters per disc was (see page 28).
attempted.
Full Entering a name exceeding the limitation of You can enter up to 100 characters per name
100 characters per name was attempted. (see page 28).
Erase Name Name input cannot be performed because Erase the name information retained in the unit. Or,
the unit retains name information for write the retained name information to the previous
a previous disc. disc and then enter name information to the new disc
(see pages 28, 32).
A.Finalize Name input cannot be performed during Cancel auto finalization before performing name input
auto finalization. (see pages 19, 23, 28).
Memory Full Programming more than 25 tracks was You can program up to 25 tracks.
attempted.
Cannot Edit Editing a finalized CD-RW was attempted. Unfinalize the CD-RW before attempting disc edit
(see page 36). This message also appears during
random playback, memory playback, or other
situations where disc editing is not possible or
when an ineditable disc is used.