Oki 3037 - Manual (Page 447)

ES 3037/3037e Accessories • 447
feel the board engage the connector, then make sure the
white tabs come up to lock the module in place.
ugc9_073.jpg
4. Replace the main board and secure it with the two screws.
5. Reconnect the printer interface cable and power cable, then
switch on the printer.
6. Print a MenuMap (see “Printing the MenuMap” on page 44) and
check that the Total Memory Size shown at the top of the
MenuMap matches the memory now installed in the printer. If it
doesn’t, turn the printer off and pull out the main board and
check to be sure that the modules are all firmly seated in their
connectors.
7. In the printer driver(s), change the installed memory to match
the new value:
– For Windows XP: see page 91
– For Windows 2000: see page 172
– For Windows Me/ 98/95 (PostScript driver only): see
page 253
– For Windows NT 4.0: see page 323
NOTE
If the error message SERVICE CALL/034 appears on the LCD
after switching the printer on, turn the printer off and pull the
main board back out and make sure the memory modules
have been installed correctly.