Telular SX4D - Manual (Page 18)

Step 5. Optional Wall-Mount Installation
SX4D GSM 900 • SX4D GSM 1800 17 U SER M ANUAL
83 mm (3-1/4 inches)
Pre-Installation Tips:
•
Make sure the location is dry, away from
overhead water pipes, and protected
from weather conditions.
•
The area should be free of airborne con-
taminants.
•
The Phonecell SX4D power supply
should be located within two meters (six
feet) of an AC power outlet.
Wall-Mount Instructions:
1) The Phonecell SX4D comes equipped
with a handset mounting clip for wall-
mounting applications. Remove the clip
from the cradle - see Figures 10 and 11.
2) Insert the handset mounting clip with
the tab pointing up - see Figures 10
and 11.
3) To mount the Phonecell SX4D on a
wall, mark two hole locations 83 mm (3-
1/4 inches) apart. Use the tick marks on
the edge of this page as a template.
These hole locations match the mount-
ing hooks on the back of the unit - see
Figure 9.
4) Using the two hole locations marked
above, drill two holes into the wall.
5) Install the screws (not supplied), into
the wall,leaving a gap (approximately 3
mm (1/8 inch)) between screw head
and wall.
6) Mount the Phonecell SX4D onto the
screws - see Figure 12.
Figure 11 – Handset mounting clip assembly.
Mounting
Clip in
Cradle
(tab up)
Figure 10 – Handset mounting clip assembly for
wall-mount applications.
Insert
Mounting
Clip into
the Cradle
(tab up) Remove
Mounting
Clip from
the Cradle
(tab down)
Figure 12
Figure 9 – Phonecell SX4D mounting hooks and
battery access door located on the back of the unit.
Mounting
Hooks
83 mm (3-1/4 inches)
Battery
Access
Door
Battery
Access
Door Tab
Your Phonecell SX4D may be mounted on a wall. Be sure to test call quality in the
selected location before you permanently mount the Phonecell SX4D to the wall.