Telular SX4D - Manual (Page 32)

SX4D GSM 900 • SX4D GSM 1800 31 U SER M ANUAL
Phonecell SX4D Programming - continued
Exit Programming Mode
The programming mode can be exited by any one of the following:
1. Go “off-hook” (pick up handset)
2. Failure to enter the correct password three times (technician mode only)
3. Failure to enter any digit within two minutes.
The PM (Programming Mode) icon is then turned off, returning the Phonecell
SX4D to the Normal Mode.
Phonecell SX4D User-Programming Commands
The following commands are displayed when in the user programming mode. An
<entered value> is comprised of the digits 0 through 9.
How to Enter Call Alert Volume
The following key sequence is used to enter the volume of the call alert:
Label: CALL ALERT VOL
Data: <volume>
The volume value is set to 0 for off; 1 for low; and 2 for high. If the
volume value is greater than 2, it is considered invalid. The factory
default is 2.
Enter Auto Send Delay
The following key sequence is used to enter the auto send delay:
Label: AUTO SEND DELAY
Data: <delay>
If the delay is not in the range of 2 to 20 seconds, it is considered
invalid. The factory default is 3.
Enter RSSI Display Type Option
The following key sequence is used to select the RSSI display option:
Label: RSSI DISPLAY
Data: <type>
The type value is set to 0 for direct readout in dBm or 1 for bar graph.
If the RSSI display type value is greater than 1, it is considered invalid.
The factory default is 0.
Enter LCD Display Contrast
The following key sequence is used to enter the LCD Display Contrast:
Label: LCD CONTRAST
Data: <contrast>
If the LCD contrast is not in the range of 0 (darkest contrast) to 19
(lightest contrast), it is considered invalid. The factory default is 10.
Enter Zero-Delay Dial
The following key sequence is used to enter the Zero Delay Dial option:
Label: ZERO-DELAY DIAL
Data: <zero-delay dial>
The zero delay dial value is set to 0 for Disable and 1 for Enable. The
factory default is 1 (Enable).